- Wayne dalton idrive remote install#
- Wayne dalton idrive remote full#
- Wayne dalton idrive remote code#
See “What is the 10-5 procedureĪ: Your remote should open your door from 50 to 75 feet away. the wall station will require activation if new and if used will require reactivation to enable teach commands to be sent. Note: For wireless wall stations with a green L.E.D. For operators with yellow antenna wires the convenience light will flash on and off three times indicating a successful learn, for all others operators the program status indicator will extinguish indicating a successful learn. Within 60 seconds press and release the light switch on the wall station. See “What is the 10-5 procedure”Ī: Press and release the program switch at the left rear side of the operator, the program status indicator will come on solid.
the transmitter will require activation if new and if used will require reactivation to enable teach commands to be sent. Note: For transmitters with a green L.E.D. Within 60 seconds press and release the desired button on the remote. The revolutionary Model 9800 fiberglass-clad door combines the realism of wood with the insulation benefits of its steel inner shell.Ī: Quantum and Classic Drives with black or green antennas are 303 Mhz, orange or red antenna wires are 433 Mhz, dual antenna boards, white antenna wire and yellow antenna wire are both 303 Mhz and 372.5 Mhz, white antenna wire is 303 Mhz and yellow antenna wires are 372.5 Mhz except Z-wave prodrives which are 372.0 Mhz.Ī: Press and release the program switch at the left rear side of the operator, the program status indicator will come on solid. The X-10 Bridge converts X-10 signals to Z-Wave technology so you can still use what you have and simply add to it with the Wayne-Dalton Home Control system.Ī: Yes.
Wayne dalton idrive remote code#
¼ turn will equal 1” less door travel.Ī: No, the operator is not designed for a one piece door and the safety features will not work properly if installed on a one piece doorĪ: No, photoeyes are safety sensors and need to be mounted no more than 5" above the floor to the center line of the safety sensor bracket.Ī: No, photo eye safety sensors are required on all Quantum, Classic Drive and prodrive operators are requiredĪ: No, this is a potential safety issue and a code violation.Ī: You only need an X-10 Bridge if you have an existing home automation system that utilizes this technology. Turn the “OPEN” travel adjustment screw at the bottom of the operator clockwise to decrease amount of open door travel. Q: Where can I buy replacement parts for my prodrive model?Ī: The most likely cause is the open travel limit is set too far open and the carriage is striking the stop bolt. Q: What is the battery life on the transmitters? Keyless entry? Wireless Wall station?
Wayne dalton idrive remote full#
Q: My door will not close, from open it travels a short distance downward and then reverse to full open, what is the problem? Q: My door travels closed but stops and reverses to full open before it reaches the floor, what is the problem? Q: My door travels all the way to the floor then reverses and returns to full open, what is the problem? Q: My door stops short of the floor, what is the problem? Q: My door does not open all the way and the light flashes after it stops, what is the problem? Q: My door does not open all the way and the light does not flash after it stops, what is the problem? Q: Is my operator Z-wave (Home Access) compatible? Q: How many Wall Stations can I program into my operator Q: How many transmitters can I program into my opener? Q: How many keyless entry's can I program into my operator? Q: How far away from my door should I be able to operate my door using a remote? Q: How do I teach my wireless wall station to my operator? Q: How do I teach a remote to my operator? Q: How do I determine what radio frequency my operator is? Q: Does Wayne-Dalton produce Fiberglass Garage Doors? Q: Can I run my operator from an extension cord?
Q: Can I operate my opener without the photo eyes? Q: Can I mount the photo eyes high above the door to get them out of site?
Wayne dalton idrive remote install#
Q: Can I install my operator on a one piece door? Q: After my door opens the light flashes on and off for a minute, how do I correct this?
0 kommentar(er)
